KC200 Firmware Update Loop
KC200 Firmware Update Loop
KC200 Firmware Update Loop
2019-04-11 17:45:59
Model: KC200
Hardware Version:
Firmware Version:

Brand new KC200 that I was able to configure and add with Android Kasa app. After getting it added, it said firmware updates so I clicked the button to start the firmware update. Now it's been a constant firmware update process, camera tab of the Kasa app shows its status of either 0 or 100%, but it never seems to finish and stays in a constant update loop. At times I get a solid green light on the camera and then next thing it starts blinking again and the app shows 0%. Per the network reports from my router it is pulling in data but it just does not seem to be able to complete. Any suggestions? Will a hard reset of the camera have to be done? 

 

Any info is appreciated. 

0
0
#1
Options
1 Reply
Re:KC200 Firmware Update Loop
2019-04-11 18:14:14

@MGM 

 

The upgrade process should take no more then 5 minutes at the most. If the camera has been in that state loop state for a extended period of time, there may have been an issue during the update. Exit the Kasa app, and reboot the camera. Wait for the camera to boot up, if it goes amber and green, set it up again, if it is solid green you should be fine. If the LED does anything else, press and hold the reset for 10 seconds to default it, and set it up again. Should the camera still remain unsresponsive, contact our support at that point.

0
0
#2
Options