Parental control when I set the time limit the devices won't come on at the allowed time. Is it possible that the router is set to another time zone
By
Doshia
· Latest post Yesterday
0Helpful
22Views
As referred to in the title, I'd like to be able to remove the banner ad from the bottom of the screen on the router firmware. The banner ad takes up roughly a 6th of the screen space. There are certa
Feature Request
By
-Kevin_N
· Latest post Yesterday
0Helpful
38Views
Just installed Deco XE75 3 module unit hardwired to cat 6 cable. During initial setup hookup base unit to modem and installed remaining modules with wifi. After setup moved units to final locations an
By
Redsoxbill
· Latest post Yesterday
by Carl
0Helpful
32Views
Has anyone tried 1.0.20 Build 20240726 Rel. 12243 for the BE85(US)/V2.6? I saw it in the downloads section and was wondering if I should put it on.
Firmware UpdateWi-Fi 7
By
Iceman803
· Latest post Yesterday
0Helpful
23Views
One of my two satellite decos is not lighting up on its led. It feels warm, like it is working, and it shows it's connected sometimes, but it disconnects all the time. No devices are connecting to it.
By
Thelonias25
· Latest post 16 hours ago
by Thelonias25
0Helpful
33Views
I would like to extend the IoT portion of my BE11000 network. The three BE11000 devices all use wireless backhaul, and work well. However, there are a few outside IoT devices that do not recieve a sig
By
CRB11112222
· Latest post Yesterday
by Riley_S
0Helpful
36Views
Hello, I have an AX11000 with the IoT devices on the guest (2.4Ghz and 5.0Ghz-1) network. I am trying to expand the range for just these two antennas. Would I be able to pick up a RE220, configure One
By
phillynick
· Latest post Yesterday
by terziyski
0Helpful
39Views
Hi folks - I installed a Deco X20 mesh network a couple of years ago, and it basically solved all my Wifi problems. So when a friend needed a better Wifi network, I recommended X20 for him also. But w
manage networks
0Helpful
41Views
Trying to setup device and iOS keyboard would not appear when forms required input. Tried to use and it works but only in portrait mode. Not a good situation.
By
Millstore
· Latest post Monday
0Helpful
19Views