MJ24k wrote

I just bought these smartplugs I went through all the set up steps. I connected a couple lamps to the two smart plugs I set up. I set a schedule for the lamps. They should be off, but they are on.

 

I reset the schedule, and I also rebooted my router. No change.
 

While I was doing the set up for the smart plugs, I received a prompt to update the firmware. When I tried, the firmware update failed.  I received a message that I could go back into the app and update the firmware.

 

When I go into the app, and go to the firmware section, I receive a message that firmware of all connected devices is up to date.

My hardware version is 1.0. I don't know what the V in the drop-down menu for hardware drop-down box signifies.

 

any suggestions?

 

  @MJ24k 

For the schedule issue, you can check suggestions here: What to do if schedule/timer/away mode not working properly for Tapo/Kasa smart Plug/Switch/Bulb/Light Strip

About the firmware, the current latest firmware for EP10 V1.0 is 1.1.1, so that means yours is the latest. Don't worry about it.