Access Points
The Access Point products are mainly designed to establish a wireless network, and, with multiple working modes, you can also expand your existing wireless network or provide internet access to your wired only devices. In this section you can say hello to other members, ask, answer or discuss technical topics regarding Access Points.
Access Points
I have 2 new out of the box EAP245 access points. They are a couple of years old, but just unboxed. I'm attempting to configure them to update the firmware and assign passwords, but can't seem to get
1Helpful
29Views
Bandarcolok pasti bisa di akses dengan mudah, dengan ketik ini di pencarian kamu >> INGATCOLOK.COM pasti bisa di akses dengan mudah setiap harinya, pastikan kamu bermain mudah dan gampang di bandarcol
Range Extender ModeClient ModeMulti-SSID Modebandarcolok
By
kodox
0Helpful
163Views
This is a generic question for the signal experts out there about ceiling mounted access points. I want to use a ceiling mounted AP at my house, and I narrowed it down to one of the entry level/small
2Helpful
52Views
Thanks in advance for any assistance anyone can offer. I have a hardwired backhaul network with four access points: TP-Link router (currently wifi off); two EAP-225 Outdoor WAPs and one EAP-110 Outdoo
0Helpful
154Views
When I try to browse to my WAP, it usually times out. The IP Address is 10.1.1.4. I also have a TL-SG105E with an IP Address of 10.1.1.3. I'm able to get to the TL-SG105E just fine. I mention that as
0Helpful
97Views
EDIT: I rebuilt everything from the ground up and it's working fine now. Not sure what was causing it so I won't be able to tell you if you ask. My WAP is connected to a pfSense router. pfSense is con
Multi-SSID Mode
2Helpful
136Views
I have a EAP 650 outdoor access point that is connected through a POE connector to the Starlink via the Starlink poe connector. After set up the access point works fine through the Omada app but then
Access Pomt
By
Andrew1971
· Latest post 2024-04-09 00:00:01
by terziyski
0Helpful
177Views
Hello, I am thinking of getting the OC200 controller and pair it with 3x AX1800 access points. I will have one AP in my office connected to my PoE switch, which should power on the AX1800. However, I
By
Vinnie1234
· Latest post 2024-03-28 19:28:19
by terziyski
0Helpful
96Views
I bought this access point to extend the wireless network into the back of our apartment. I currently have an Archer A7 connected to my modem and a cable running to a switch in the back. The AP is con
0Helpful
161Views
I just purchased a TP-LINK AXE7800 router and TP-LINK TLWA 3001 access point to create a strong network signal so that I can install wifi security cameras around the property. I have a large house wit
By
Vdefeo3315
· Latest post 2024-02-06 00:16:33
by terziyski
3Helpful
275Views