TL-SG1016DE Port Trunking
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG1016DE Port Trunking
Model :
Hardware Version :
Firmware Version :
ISP :
I just upgraded my home network. In preparation of this upgrade i purchased this switch TL-SG1016DE in order to use port trunking. No Vlans or anything just binding two 1000gb ports for more speed with the new NAS and router.
The Router is Asus GT-AC5300
The NAS is Qnap TS 251
On the Switch I set port 16 and 15 to trunk 1 and port 14 and 13 to trunk 2
I set the router and NAS to trunk 2 ports each
Plug it all in and the network slows to a crawl and error packs start up.
What gives? I am guessing the 2 new devices are too smart for the smart switch.
If this switch cannot do it then what specs should i look for in a new one.
I am planning to upgrade my CCTV to IP cameras and NVR and using Vlans to keep traffic on the NAS down to a reasonable level
Thank you
Chuck
Hardware Version :
Firmware Version :
ISP :
I just upgraded my home network. In preparation of this upgrade i purchased this switch TL-SG1016DE in order to use port trunking. No Vlans or anything just binding two 1000gb ports for more speed with the new NAS and router.
The Router is Asus GT-AC5300
The NAS is Qnap TS 251
On the Switch I set port 16 and 15 to trunk 1 and port 14 and 13 to trunk 2
I set the router and NAS to trunk 2 ports each
Plug it all in and the network slows to a crawl and error packs start up.
What gives? I am guessing the 2 new devices are too smart for the smart switch.
If this switch cannot do it then what specs should i look for in a new one.
I am planning to upgrade my CCTV to IP cameras and NVR and using Vlans to keep traffic on the NAS down to a reasonable level
Thank you
Chuck