
Wireless
Note 1. The minimum update firmware version and the recommended management controller/app version are listed below: Series Min Update Firmware Version Recommended Controller/APP EAP65x/ EAP67x EAP650
47Helpful
8742Views
This Article Applies To: EAP772 V1 EAP773 V1 EAP783 V1 Note 1.To update to this pre-release version, please make sure your device version is not lower than the version listed below: 1.1.2 Build 202510
7Helpful
1123Views
Early AccessEAP65x | EAP603-Outdoor Pre-release Firmware Adapted to Omada v6.3 (Updated on 31st Aug 2026)
This Article Applies To: EAP650-Desktop V1.0, Fully Adapted to Omada SDN Controller v6.3. EAP650 V2.0, Fully Adapted to Omada SDN Controller v6.3. EAP650 V3.0, Fully Adapted to Omada SDN Controller v6
40Helpful
5163Views
This Article Applies To: EAP655-Wall 1.0 Note: 1. To update to this pre-release version, please make sure your device version is not lower than the version listed below: 1.6.8 Build 20260828 Rel. 0827
0Helpful
406Views
This Article Applies To: a) EAP655-Wall (EU/JP/AU/CA/KR) 1.0 b) EAP655-Wall (EU) 1.20 Note: 1. To update to this pre-release version, please make sure your device version is not lower than the version
By
Nathan-TP
0Helpful
339Views
Overview The purpose of this Early Access post is to offer you with a chance to experience the new features and updates of TP-Link Omada products in advance, and also give us TP-Link the opportunity t
Firmware UpdateHighlighted ThreadOfficial
12Helpful
91515Views
Hi everyone. I own a TP-Link EAP772-Outdoor(US) v1.0 access point, currently running firmware version 1.5.3. I am physically located and operating the device in Canada. The 6GHz radio is unavailable,
By
Burnski
· Latest post 51 minutes ago
by Solla-topee
0Helpful
36Views
EAP245 doesn't appear or show its serial number in Omada Software Controller and can't connect to Wi-Fi. EAP245 can ping gateway and 8.8.8.8 EAP245 (US) v3.0 | version: 5.3.3 Omada SDN Controller vers
By
alannlop
0Helpful
20Views
Hi, I have been setting up an EAP225-Outdoor AP and have used the Standalone (web browser) method to configure the unit with success. The web based management of the unit works well but as I was consi
By
NeilGriffin
· Latest post 22 hours ago
by NeilGriffin
1Helpful
111Views
