Switches
i want to use ip camera morethan 300 thats why i am using olt networking how to config
VLAN & Multi-NetworksConfigurationNetwork Connectivity
By
punda
0Helpful
6Views
The switch model is actually an SG2008 and the hardware version is v4.20. In the release note for the latest firmware, under new features it states "Added support for Private VLAN". Is any guidance av
VLAN & Multi-NetworksConfiguration
By
jra11500
0Helpful
18Views
I have the SG2428P(UN) 5.30, currently running FW 5.30.18 Build 20260310, standalone mode. First symptom I noticed on first boot was slow responsiveness - clicking any item on web management interface
By
TS_QRL
0Helpful
19Views
I have attached a topology and photograph below but the topology is a bit misleading. The problem started a week ago when I started using VLANs. Let me explain. Before, the basic topology was as below
VLAN & Multi-NetworksHealth
By
Dr_Marty
· Latest post 10 hours ago
by Vincent-TP
1Helpful
392Views
Hi all, I just upgraded this switch to the latest firmware, 1.0.21, and all the POE ports stopped outputting power. They were all working fine before this update. Is there anything that can be done to
Firmware Update
By
windows10luke
· Latest post 12 hours ago
by Vincent-TP
2Helpful
217Views
I have two SX3008F's. One of them, for some reason, always gets stuck on boot. I hooked up the serial port and found that every time it starts up, it gets interrupted by bootutil and needs me to hit '
0Helpful
110Views
I have read several articles about ES205G / GP not showing IP addresses of connected clients when working in controller mode. Sadly, issue still persists, because recently I installed ES205G in my net
ConfigurationFirmware UpdateController
By
Happy_x50
· Latest post 21 hours ago
by h3llrais3r
3Helpful
1047Views
Good Day, I recently purchased an ES210X-M2 switch, upon adopting it in the software controller (windows based) I am unable to see the IP addresses with the devices connected to the switch. I only see
TopologyControllerConfiguration
2Helpful
845Views
Release Notes New Features: 1. Added support for NAT Traversal. 2. Added compatibility with Omada Config Tools V2.0. 3. Added support for Private VLAN. 4. Added support for Lightweight DHCPv6 Relay Ag
22Helpful
11987Views
Hi, My OC300 has just prompted me to upgrade the firmware on my SG3210 v3.20 switch from firmware version v3.20.23 Build 20260423 Rel 25947 to firmware version v3.20.24 Build 20260509 Rel.23533 My swi
sg3210
By
MantonL
· Latest post a week ago
by Vincent-TP
0Helpful
209Views
I am having the same issue as https://community.tp-link.com/en/business/forum/topic/742456 with this PoE switch not powering up, but it goes beyond slave PoE devices. The problems is after a reboot, e
PoEPower-Up
By
Tintronic
· Latest post a week ago
by Vincent-TP
0Helpful
162Views
Hi all, We are experiencing a recurring issue across 10 sites where the SG3452P repeatedly goes into a heartbeat missing loop and disconnects from the Omada Cloud-Based Controller throughout the day a
Firmware UpdateControllerNetwork ConnectivityHealth
By
oewncj
· Latest post a week ago
by Vincent-TP
1Helpful
226Views