hey buddy, i think what happened is correct and these two kinda switches are different.


when u set up a LAG group, this T2600G will auto generate an entry of LAG in vlan list which has a higher priority. switch will listen to LAG vlan other than port vlan.
this is a little complicated.i give u an example then.

port 10 belongs to vlan 100 in vlan list.
LAG1 belongs to vlan 666 in vlan list.
port 10 turns on the LACP feature.
now the port 10 belongs to vlan 666 actually.

and whatever the previous port setting is, the port in LAG1 could be membered in LAG table. if the port settings are different, the port will become a unselected member.
but for T3700G, when I add a port to a LAG group there will not be an entry of LAG in vlan list. if the port is different from previous settings, it cannot be a member in LAG table.


recommend you config LAG before others like VLAN, STP to avoid errors.

Hello,
i do not understand this:
For example: i have a T2600g-52ts. On the Ports 51-52 i will configure a lacp on the configured ports with general-mode, vlan 666 as Default Vlan (untagged) and pvid 666 on this Ports. Then i will the created Vlans 10, 100 and 200 as tagged vlan configure over the created lacp, but i can only configue these Vlan's as untagged. Must i configure these Vlans in the Vlan-Register or in the LAP-Register?
Kind regards
Hartmut

Dear, u could config LAG vlan settings in the 802.1Q VLAN—>port config, UNIT—>LAGS. After changing the link type of LAG from access to general, u could set vlan of LAG as tagged.

Sorry but i can not set vlan as tagged in LAG-Mode
I will Tell you what i do:
First i switch the Ports from access to General:


Then i create my Manage-Vlan 666 and bind it to the Ports 27 and 28



Now i give these Ports the PVID 666



Then i create a lacp with Admin 2 as active and enabled, but i see no LAG in the table



In the LAG-Table there are no Member



and here you can see that the LAG is bind to the VLAN 666



When i create a new Vlan like VLAN10 there is no way to tag these Vlan to the LAG(2)



I do not know what i am doing wrong
Kind Regards
Hartmut

:cool::cool::cool:hey dear, from your screenshots im a little confused about model u use. Lol.... Ur screenshots have 28 ports, so i think it’s T3700G-28TS. But in the last two replies, you have problems with T2600. So... i list the specific configuration steps of both, you can set as a reference.
generally speaking, for T3700G, first turn on specific ports’ LACP function.



Then u will find there is nothing in LAG table.



at this point u need to connect the selected ports with the other side ports to make LAG table show as follows



Then go to 802.1Q VLAN—>port config, to switch the link type of LAG group to general.



Now u could set them as tag or untag.



They could belongs mul-vlans to meet ur demands.:D



But T2600G is another sotry. After turning on the LAG function of ports, you could directly change the LAG vlan link tpye. click LAGS to select general.



And u could add tag vlan or untag vlan to LAG freely〔^ǒ^〕.