No Default Rule Blocking All Incoming connections?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No Default Rule Blocking All Incoming connections?
Model :
Hardware Version :
Firmware Version :
ISP :
I have several TL-ER6020's and 6120's installed and recently my DVR was being attacked through a exploit to gain access and disable my cameras. So I noticed that if I try to set a Block All rule for all services using the lowest priority, it will block all Internet access from the LAN, even if there is a higher rule allowing traffic from the LAN.
Does anybody else is having this problem? Because the only workaround I've found is by blocking entire foreign networks due the increasing attacks. Patching my DVR's is not possible due the lack of support from my vendor.
Thanks for your help.
Hardware Version :
Firmware Version :
ISP :
I have several TL-ER6020's and 6120's installed and recently my DVR was being attacked through a exploit to gain access and disable my cameras. So I noticed that if I try to set a Block All rule for all services using the lowest priority, it will block all Internet access from the LAN, even if there is a higher rule allowing traffic from the LAN.
Does anybody else is having this problem? Because the only workaround I've found is by blocking entire foreign networks due the increasing attacks. Patching my DVR's is not possible due the lack of support from my vendor.
Thanks for your help.
