CPE510 V2 Office to Home Connection

CPE510 V2 Office to Home Connection
CPE510 V2 Office to Home Connection
2017-11-22 04:37:38
Model :

Hardware Version :

Firmware Version :

ISP :

I want to Connect office with my home. I allready have 2 x CPE510 V2
Distance is about 1.5km

I understand how to have a link among both AP.

My question is about Lan Configuration.

Currently at Office Network IP addresses are 10.136.56.1 to 10.136.56.254 With Mask 255.255.255.0 and Gateway at 10.136.56.1
On AP i have IP Address 10.136.56.166 and on Client 10.136.56.167.
My Router ( FIBER ) has also DHCP Server ( 10.136.56.180 - 10.136.56.254 )
If a connection is established among those 2 AP Should i leave all than configuration as it is? I mean if a connetion is established there my home computers wil get ips through DHCP service of office router?

Another Question is " can i have a different netwok ( like 192.168.1.1 - 192.168.1.254 ) at home and give IP to Client AP as 192.168.1.100, and set it ip as dhcp server? Will it work to have Internet Access through Wireless Connection from Office.

What is the best way to configure ip's and network?

An at last : Connection will be bidirectional ?

Thanks in advance
George
0
0
#1
Options
1 Reply
Re:CPE510 V2 Office to Home Connection
2017-11-22 10:03:37

geobikas wrote

If a connection is established among those 2 AP Should i leave all than configuration as it is? I mean if a connetion is established there my home computers wil get ips through DHCP service of office router?


Yes, that's correct setup for an AP and a client. You share the office network this way.

Another Question is " can i have a different netwok ( like 192.168.1.1 - 192.168.1.254 ) at home and give IP to Client AP as 192.168.1.100, and set it ip as dhcp server? Will it work to have Internet Access through Wireless Connection from Office.


Sure. You would use AP Client Router mode instead of client mode on the CPE (I'll name it CPE #2) in your home. To do so, you have to setup DHCP on the CPE #2 and define the default gateway (office router). This way, the CPE #2 works as a client on the WAN side and a router on the LAN side simultaneously.

What is the best way to configure ip's and network?


Depends on what you wan't to achieve. In first scenario your home network is part of the office network, so you can reach other severs in the office. In the second scenario you create an isolated home network, which might share Internet through the office router, but does not allow to access your home network from the office.

An at last : Connection will be bidirectional ?


Yes.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
0
0
#2
Options