Problems setting management VLAN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Problems setting management VLAN
Model : CPE210
Hardware Version : V2
Firmware Version : TP_PharOS_V2.1.0_170609
I am having a hard time setting a management VLAN on my CPE210. My CPE210 has a fixed IP address of 192.168.10.10 on subnet 192.168.10.0/24. I set a static IP address on my network interface (192.168.10.70) and log in to the admin mode of my CPE210.
Then I set the management VLAN to 10 and everything freezes. I disconnect the network cable from my computer and put it in my VLAN aware router which send a trunc containing VLAN10 (amongst other VLANs).
When I connect my computer to an access port with VLAN10, I can't reach 192.168.10.10 (i.e. the CPE210). When I restart the CPE210 I am able to connect to it when the network cable once again is connected to my computer.
It seems like the mgmt VLAN of the CPE210 won't set. Any ideas?
Hardware Version : V2
Firmware Version : TP_PharOS_V2.1.0_170609
I am having a hard time setting a management VLAN on my CPE210. My CPE210 has a fixed IP address of 192.168.10.10 on subnet 192.168.10.0/24. I set a static IP address on my network interface (192.168.10.70) and log in to the admin mode of my CPE210.
Then I set the management VLAN to 10 and everything freezes. I disconnect the network cable from my computer and put it in my VLAN aware router which send a trunc containing VLAN10 (amongst other VLANs).
When I connect my computer to an access port with VLAN10, I can't reach 192.168.10.10 (i.e. the CPE210). When I restart the CPE210 I am able to connect to it when the network cable once again is connected to my computer.
It seems like the mgmt VLAN of the CPE210 won't set. Any ideas?