Bridge between two cpe510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bridge between two cpe510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bridge between two cpe510
Bridge between two cpe510
2018-02-13 04:34:43
Model :

Hardware Version :

Firmware Version :

ISP :

Hello, I would like to know if someone did something like in the diagram, I do not know if it is the correct way, I have a client halfway with good reception and I would like to put an antenna so that my most remote clients can connect to that antenna. I use TP-LINK Pharos CPE510. If someone did, tell me your solution.



  0      
  0      
#1
Options
1 Reply
Re:Bridge between two cpe510
2018-02-16 01:45:00
Works this way, but you should run the CPE connecting to the leftmost AP in Client mode, not in Bridge mode (it's still working as a bridge or more precisely, as a relay station in RF terminology).

But note that latest CPE510 don't have a LAN1 port anymore. If you manage to get v1.1 hardware, they have a second LAN1 port and the setup is possible as shown in your picture.

With v2 hardware you can't use PoE Passthrough on the two CPEs connected by wire, so you will have to use a switch to connect AP2 and CL1 to the CPE.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options