EAP110 Outdoor PoE - split 2 pair PoE to 4 pair
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP110 Outdoor PoE - split 2 pair PoE to 4 pair
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I purchased the EAP110 Outdoor to be able to access my odroid xu4 arm computer over a longer wifi range. I intended to connect the odroid xu4 ethernet port to the injector and the PoE cable from the injector to the EAP110 outdoor. I have a limitation of 2 pair PoE wire from the injector to the EAP110 outdoor, as it passes through a 5 wire slipring. See the attached sketch.
I need to use a 2 pair PoE from the injector, and request advice on how to split the power and data from a 2 pair PoE to a 4 pair for the EAP110 outdoor POE input.
Thanks
Gary
Hardware Version :
Firmware Version :
ISP :
Hello,
I purchased the EAP110 Outdoor to be able to access my odroid xu4 arm computer over a longer wifi range. I intended to connect the odroid xu4 ethernet port to the injector and the PoE cable from the injector to the EAP110 outdoor. I have a limitation of 2 pair PoE wire from the injector to the EAP110 outdoor, as it passes through a 5 wire slipring. See the attached sketch.
I need to use a 2 pair PoE from the injector, and request advice on how to split the power and data from a 2 pair PoE to a 4 pair for the EAP110 outdoor POE input.
Thanks
Gary
Re:EAP110 Outdoor PoE - split 2 pair PoE to 4 pair
Thanks Tacman. The Odroid to the injector was not a problem, and I can use cat5e cable. The problem was the PoE from the injector to the EAP110. The EAP110 requires a 4 pair input, but I had a limitation that I could only use a maxiumum 5 wires via the slipring. I was advised to use this connection through the 5 wire slipring. It works, and the problem was solved.
