Enabling DynDNS on CPE510?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Enabling DynDNS on CPE510?
Model : CPE510
Hardware Version :
Firmware Version : CPE610(UN)_v1.0_20180327
ISP : Several!
Hello,
I have two CPE510's with one configured as an AP and the other as a CLIENT, I attempted to enable the Dynamic DNS (DynDNS or DDNS) capability (on both), however, the menu item is grayed out and not modifiable! There is no "Enable" check box!
I am running firmware "CPE610(UN)_v1.0_20180327" (based on the recommendation from another thread, due to the problems I was experiencing on another unrelated RF link reliability issue).
Does anyone know how to enable the feature via the SSH command line? Looking at the HTML source, it seems to be using a "controller.js" and "model.js" scheme with defines to control various capabilities and the Dynamic DNS feature should be enable...
Thanks.
Hardware Version :
Firmware Version : CPE610(UN)_v1.0_20180327
ISP : Several!
Hello,
I have two CPE510's with one configured as an AP and the other as a CLIENT, I attempted to enable the Dynamic DNS (DynDNS or DDNS) capability (on both), however, the menu item is grayed out and not modifiable! There is no "Enable" check box!
I am running firmware "CPE610(UN)_v1.0_20180327" (based on the recommendation from another thread, due to the problems I was experiencing on another unrelated RF link reliability issue).
Does anyone know how to enable the feature via the SSH command line? Looking at the HTML source, it seems to be using a "controller.js" and "model.js" scheme with defines to control various capabilities and the Dynamic DNS feature should be enable...
Thanks.
