Port-Flapping and Duplex/Speed-Issues
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is there anybody else having issues with port-flapping and speed/duplex-Settings? I have a printer which can do 100/Full-Duplex but only connects on 10/Half-Duplex no matter which setting I use on switch or printer side. And I have a device connected via 30m cable which does constant port-Flappings.
Tried different cables, made sure "eee" is disabled...
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Sorry I never came back to this - actually never saw a message I had a reply...
Printer
Yes it was going 10/HD - but why?
Answer: It went to power save mode. If I wake it up it goes back to 100/FD - so no issue on the switch. Funny enough: You hard set it to 100/FD on the printer and it still does the same thing - I do this with the switch, the printer is not available until it wakes up from sleep.
Device Port flapping
Device can do 1000/FD and is connected with a CAT 5e cable. Setting it to 100/FD. It used to be connected with a 50m (not 30m as previously stated) CAT 5e cable - what I did not mention is that it is an Access point having a Power Injector inbetween. Putting a dump switch just before the Power connector stabalized the link - so no issue on the switch.
To make things worse: I have the Access Point now connected to the very same switch but only using a total of 5m CAT6 cable including the Power Injector and the flapping re-emerged. I have similar configurations across my setup without any issues and I suspect a faulty Power Injector or the AP is damaged.
- Copy Link
- Report Inappropriate Content
AZeroEight wrote
Is there anybody else having issues with port-flapping and speed/duplex-Settings? I have a printer which can do 100/Full-Duplex but only connects on 10/Half-Duplex no matter which setting I use on switch or printer side. And I have a device connected via 30m cable which does constant port-Flappings.
Tried different cables, made sure "eee" is disabled...
100/Full-Duplex only needs to use CAT5 cable. And you can try to use the PC to connect the switch and force the speed to 100M for both devices, in order to check if the switch can reach 100M.
- Copy Link
- Report Inappropriate Content
Sorry I never came back to this - actually never saw a message I had a reply...
Printer
Yes it was going 10/HD - but why?
Answer: It went to power save mode. If I wake it up it goes back to 100/FD - so no issue on the switch. Funny enough: You hard set it to 100/FD on the printer and it still does the same thing - I do this with the switch, the printer is not available until it wakes up from sleep.
Device Port flapping
Device can do 1000/FD and is connected with a CAT 5e cable. Setting it to 100/FD. It used to be connected with a 50m (not 30m as previously stated) CAT 5e cable - what I did not mention is that it is an Access point having a Power Injector inbetween. Putting a dump switch just before the Power connector stabalized the link - so no issue on the switch.
To make things worse: I have the Access Point now connected to the very same switch but only using a total of 5m CAT6 cable including the Power Injector and the flapping re-emerged. I have similar configurations across my setup without any issues and I suspect a faulty Power Injector or the AP is damaged.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1952
Replies: 2
Voters 0
No one has voted for it yet.