CPE 210 ACCES POINT AND CLIENT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE 210 ACCES POINT AND CLIENT

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE 210 ACCES POINT AND CLIENT
CPE 210 ACCES POINT AND CLIENT
2019-10-05 15:00:00 - last edited 2019-10-11 06:15:07
Model: CPE210  
Hardware Version: V1
Firmware Version: 1.3.3 Build 20160526 Rel. 4923

I have set  up two CPE 210 devies as Acces point and client to carie internet network over 100 meters at most.I am not sure about the settings as concernd the maxtreem setting or not.

Actully it already works but iam trying to get the most perfomance I CAN.

The acces point reches out 95 to 100 CCQ.iS that OK?

 

The client has th following mesurements:signal strength -58dbm

                                                                 noise strength -102dbm

                                                                   SNR              43DB

                                                                    transmit CCQ  100

 

   

 

 

 

-100dBm

SNR:  

 

 

 

41dB

Transmit CCQ:  

 

 

 

100

LAN

  0      
  0      
#1
Options
1 Reply
Re:CPE 210 ACCES POINT AND CLIENT
2019-10-11 14:20:17 - last edited 2019-10-11 14:21:18

43 dB SNR is pretty good. To enhance speed, set 20 MHz channel width, 802.11n-only WiFi mode and specify the actual distance between the CPEs. MAXtream isn't needed between only two CPEs, it makes sense only for PtMP, but not so much for PtP links.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 1018

Replies: 1

Related Articles