Pharos firmware version 2.2.2 has been released
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Pharos firmware version 2.2.2 has been released that fixed some serious bugs:
1.Fixed the problem that CPE might crash caused by stack overflow.
2.Fixed the compatibility problem with MikroTik AP.
3.Fixed the problem that CPE might fail to scan and connect to some AP's SSID.
4.Fixed the problem that CPE with client mode might fail to connect to AP with 802.11a mode only.
https://static.tp-link.com/2020/202001/20200102/CPE610(UN)_V2.0_2.2.2_Build%20191213.zip
But this time the firmware is for CPE610 V2 only and can't be flashed on older (and other) units (CPE210 v1, CPE510 v1, etc.) like v2.2.1
That means only CPE610 V2 has these bugs?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@phongtom Yes, i am trying to install in a WBS210 v1.20 with 2.2.1 and is displayed the "Hardware not supported" error message. I think now they are fixed the correct hardware version of the device, which check if is developed to them, or the new CPE610 hardware have another or different chipset
- Copy Link
- Report Inappropriate Content
Galenito wrote
Yes, i am trying to install in a WBS210 v1.20 with 2.2.1 and is displayed the "Hardware not supported" error message.
Firmware v2.2.1 for WBS210 is here (and yes, it installs on HW v1.20 too):
https://static.tp-link.com/2019/201907/20190725/WBS210(UN)_V2.0_2.2.1%20Build%20190620.zip
It's firmware v2.2.2 which is missing for WBS and other CPE[25]xx models.
CPE610 was never fully compatible with WBS/CPE[25]xx since CPE610 has fewer LEDs. You could install its earlier firmwares on WBS/CPEs, but then the LED display did'nt work as expectetd.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
NO NEWS??? i see the same 2.2.2 in different downloads country sites...
- Copy Link
- Report Inappropriate Content
@Galenito, where did you see it?
I looked for just yesterday and still no V2.2.2 for WBS510/210 or CPE510/210 on international or EU sites. Please share if you found the firmware for WBS/CPE.
- Copy Link
- Report Inappropriate Content
Is there any news?
- Copy Link
- Report Inappropriate Content
@phongtom any update for cpe510, my cpe510 v3.0 lost signal.
in the new ship device find 2.2.1 but is not possible to update device 2.2.0 , no download for the 2.2.1 firmware.
you have a link for download 2.2.1 for cpe510 (eu)?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 6090
Replies: 8
Voters 0
No one has voted for it yet.