Business Community > Switches > installation (setup) gateway for administration t1600
< Switches

installation (setup) gateway for administration t1600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

installation (setup) gateway for administration t1600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
installation (setup) gateway for administration t1600
installation (setup) gateway for administration t1600
2020-01-27 22:38:16
Model: T1600G-28PS(TL-SG2424P)  
Hardware Version: V3
Firmware Version:

Hello!  please tell me how to install gateway on t1600 for administration? I can’t figure out how to configure the gateway.  thanks!

  0      
 
  0      
 
#1
Options
4 Reply
Re:installation (setup) gateway for administration t1600
2020-01-28 00:54:39 - last edited 2020-01-28 00:55:34

@TheKaban, you set up the default gateway using a static route with destination IP 0.0.0.0 and the gateway's IP as next hop.

See https://www.tp-link.com/us/support/faq/2123/

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:installation (setup) gateway for administration t1600
2020-01-28 00:59:46

@R1D2, hi!) thanks for the answer!) I understand that, but I can not find the static routing tab.  if I can’t find it, I will do it through the CLI

  0  
  0  
#3
Options
Re:installation (setup) gateway for administration t1600
2020-01-28 01:27:14

According to the FAQ I linked to:

 

Go to L3 FEATURES > Static Routing > IPv4 Static Routing and click  to load the following page. Enter 0.0.0.0 as the Destination and Subnet Mask, and enter the IP address of the Next Hop (Default Gateway). Then Click Create.

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options
Re:installation (setup) gateway for administration t1600
2020-01-29 01:34:56

@R1D2 , Hello!  thanks for the answer!  The problem was that I came in from someone else's laptop, and there was a stripped down browser.  part of the menu was not displayed.  all right, false alarm.

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1062

Replies: 4

Related Articles
Need some guidance on VLAN setup
2217 0
IPv6 Default Gateway in Static routes - IP not accepted
712 0
 How to setup a LAG (LACP) link between 2 switches (T1600G-28PS(TL-SG2424P))
1825 0
 Trouble connecting T1 and cable broadband tohtger
326 0
Linking 2 T1600G-28PS switches
1003 0
Help with T1600G-28PS hardware V2/V3 and SDN compatibility
3438 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.