Advice sought by newbie on setting up CPE210 and IP/Wifi camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Advice sought by newbie on setting up CPE210 and IP/Wifi camera
Advice sought by newbie on setting up CPE210 and IP/Wifi camera
2020-02-18 17:44:22 - last edited 2020-02-20 07:38:23
Model: CPE210
Hardware Version:
Firmware Version:

Advice sought by newbie on setting up CPE210 and IP/Wifi camera.

 

I have set up CPE210, one as an AP (to computer via router), the other as Client (to cctv camera).

 

All LED's on both CPE210's are OK, and signal strength full.

 

1 - However when going into PharOS it says that the client is disabled ?? any ideas.

 

2 - Antenna distance has been set to 1km. Can this be causing an overload if distance for testing is 50m.

 

Many thanks

 

 

0
0
#1
Options
1 Reply
Re:Advice sought by newbie on setting up CPE210 and IP/Wifi camera
2020-02-20 14:08:28 - last edited 2020-02-20 14:09:04

@grayb, you should set »Distance« setting to either »Auto« or to the actual distance. Also make sure the CPEs are carefully aligned to each other, this is important for directional links.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
0
0
#2
Options