Business Community > Pharos Wireless Bridges > CPE210 V1.1 How to limit access to certain IP range?
< Pharos Wireless Bridges

CPE210 V1.1 How to limit access to certain IP range?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE210 V1.1 How to limit access to certain IP range?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE210 V1.1 How to limit access to certain IP range?
CPE210 V1.1 How to limit access to certain IP range?
2020-04-09 07:08:57
Model: CPE210  
Hardware Version: V1
Firmware Version: 2.1.6 Build 20170908 Rel. 45233 (4555)

My CPE210 is operating in Repeater Mode and is being accessed via WiFi by 5 surveillance cameras with fixed IP Adresses. The adresses of the cameras are consecutive in the last digit. I'd like to limit access to the CPE210 to only those 5 cameras which form a small range. How can I best do that?

 

Thanks in advance and regards from Bavaria, Germany,

Mario

  0      
 
  0      
 
#1
Options
4 Reply
Re:CPE210 V1.1 How to limit access to certain IP range?
2020-04-09 13:32:57

@MarioT, you can use the MAC filter setting to restrict connections from the cams to the CPE. Find it in the »Wireless« menu:

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:CPE210 V1.1 How to limit access to certain IP range?
2020-04-14 07:19:24

@R1D2 Thanks for that! Yes, I am definitely aware of the MAC filtering and I have been using it up to now.

 

I am wondering if there is any ways to do the same, but with IP adresses?

 

Do you know if it is possible?

 

Cheers,

Mario

  0  
  0  
#3
Options
Re:CPE210 V1.1 How to limit access to certain IP range?
2020-04-14 12:24:58

 

MarioT wrote

I am wondering if there is any ways to do the same, but with IP adresses?

 

No, it's not possible and it would make not much sense to block clients by IP address since traffic is not IP traffic alone. There are protocols not requiring an IP address at all, thus it's not possible to deny access just by defining IPs to exclude. Clients could easily circumvent this limitation and gain access using another IP address.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options
Re:CPE210 V1.1 How to limit access to certain IP range?
2020-04-14 13:53:38

@R1D2 OK, if it isn't possible that's just fine and I don't have to look any further.

 

Thanks for that!

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1039

Replies: 4

Related Articles
 CPE210 v1.1 (with test mode) firmware
1523 0
CPE210 - Changing IP to match new network
1819 0
Cannot login to Pharos on CPE210; Spectrum IP issue
1109 0
 TP-link CPE210 V1.1
2674 0
 CPE210 suddenly has only access to a few websites
481 0
cpe210 not working
2229 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.