CPE210 - Point to point - connect router or AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE210 - Point to point - connect router or AP
CPE210 - Point to point - connect router or AP
2020-07-25 03:43:58 - last edited 2020-07-27 05:15:26
Model: CPE210
Hardware Version:
Firmware Version: 2.2.1 build 20190620

Hi.

 

I managed to make a nice Point to point connection between my 2 CPE210.

 

The host router downloads at around 70 Mbps, it sends it to the AP-CPE and with the distance, if I'm directly connected to the client CPE (with Ethernet) I get around 45 Mbps. Which is plenty for what we need.

 

But, after this step I'm stuck : I need to transform that 45Mbps into a wireless network. So I tried connecting an AP (linksys lapac1200) with no success, then I tried to connect a router (linksys AC1200) with no success. 

 

No success = I get around 2 to 4 Mbps.

 

Could it be a compatibility issue ?

Is it even possible to plug an AP or router after the client CPE ?

 

Thank you !

0
0
#1
Options
1 Reply
Re:CPE210 - Point to point - connect router or AP
2020-07-27 17:47:21

 

TaxusQc wrote

Is it even possible to plug an AP or router after the client CPE ?

 

Sure. Note that an AP extends your existing network while a router routes between your existing network (seen as WAN by the router) and the router's LAN on a normal PtP link (that's one CPE running in AP mode while the other one running in Client mode).

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
0
0
#2
Options