TL-SG105E problem whit vlan
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
good morning
bho this annoying problem with the switch in question
is configured as follows:
eth1 trunk
eth2 untagged vlan 100
eth3 untagged vlan10
eth4 untagged vlan30
eth5 untagged vlan30
the 2 devices connected on et4 and eth5 (both in the same vlan, 30) are not seen with each other (even the ping is not successful), but they see and are seen by the rest of the network
Do you have any advice to solve the problem? thank you all
if it can serve 2 devices always connected directly to the same switch but with different vlan, they ping without problems
Zippo wrote
good morning
bho this annoying problem with the switch in questionis configured as follows:
eth1 trunk
eth2 untagged vlan 100
eth3 untagged vlan10
eth4 untagged vlan30
eth5 untagged vlan30the 2 devices connected on et4 and eth5 (both in the same vlan, 30) are not seen with each other (even the ping is not successful), but they see and are seen by the rest of the network
Do you have any advice to solve the problem? thank you all