AP EAP110-OUTDOOR V3 AND CLIENT CPE210 V1 UNSTABLE

AP EAP110-OUTDOOR V3 AND CLIENT CPE210 V1 UNSTABLE
AP EAP110-OUTDOOR V3 AND CLIENT CPE210 V1 UNSTABLE
2020-08-18 15:05:58 - last edited 2020-08-19 15:26:51
Hi, I have a problem.

 

I have an AP eap110-outdoor v3 with basic configuration to share internet, it works fine, but I need to connect a CPE210 v1 as a client (both updated with the latest firmware). the point is that when connecting the cpe210 to the eap110, the eap110 becomes unstable ... I explain; I open two cmd windows by pinging each one ... (this from a connected pc on the eap110 side) the cpe210 responds to the fluid ping but the eap110 does not, many packets are lost and to configure this very slow.

 

The idea is that from the cpe210 I should connect another eap110 to repeat the signal to another area and when I do it the same thing happens ... very unstable

 

is there any incompatibility between these teams?

or some configuration mode that works well?

I have already tried with several parameters, especially wireless and it always remains the same way.



 

thank you
0
0
#1
Options
1 Accepted Solution
Re:AP EAP110-OUTDOOR V3 AND CLIENT CPE210 V1 UNSTABLE-Solution
2020-08-19 01:51:20 - last edited 2020-08-19 15:26:51
I answer myself, I was doing a loop since the cpe210 was connecting it wireless and wired at the same time without realizing it. they work perfect, there is no incompatibility.
Best Solution
1
1
#2
Options
1 Reply
Re:AP EAP110-OUTDOOR V3 AND CLIENT CPE210 V1 UNSTABLE-Solution
2020-08-19 01:51:20 - last edited 2020-08-19 15:26:51
I answer myself, I was doing a loop since the cpe210 was connecting it wireless and wired at the same time without realizing it. they work perfect, there is no incompatibility.
Best Solution
1
1
#2
Options