TL-ER6020 + T2600G-52TS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-ER6020 + T2600G-52TS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-ER6020 + T2600G-52TS
TL-ER6020 + T2600G-52TS
2020-09-15 18:08:00 - last edited 2020-09-18 08:47:47
Model: Adapter  
Hardware Version: V2
Firmware Version: 2.0.2 Build 20180702 Rel.59031

Hardware Version:
TL-ER6020 v2.0

Firmware Version:
2.0.2 Build 20180702 Rel.59031

 

Hardware Version:
T2600G-52TS 3.0

Firmware Version:
3.0.0 Build 20180202 Rel.30718(s)
 

Guide: https://www.tp-link.com/en/support/faq/887/

 

Hi there, I'm trying to achieve what the guide are suppose to. The network that I'm design are 3 VLANs (Guest, Corp, voip), each with a DHCP on the correct range address and routed to the internet.

 

TL-ER6020 Port5 - Lan (192.168.0.1) ->P1 T2600G-52TS (192.168.0.4)

Every single port of T2600 are on PVID1 vlan1 except port 1/45 which is my Yealink phone using for test (Voip vlanid 1682).

 

 

Following the guide, created the static route point the next hop to the switch ip.

 

Now at T2600

 

 

Interfaces and default route

 

 

DHCP and Pool

 

 

VLAN

 

 

 

The point is, the phone still grabbing the IP from vlan1.

 

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:TL-ER6020 + T2600G-52TS-Solution
2020-09-15 21:15:03 - last edited 2020-09-18 08:47:47
Found my self, I should UNTAG the uplink.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:TL-ER6020 + T2600G-52TS-Solution
2020-09-15 21:15:03 - last edited 2020-09-18 08:47:47
Found my self, I should UNTAG the uplink.
Recommended Solution
  0  
  0  
#2
Options