CPE510 Poe not working on Access Point side now

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 Poe not working on Access Point side now

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bobert540

2020-09-30 23:02:21

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-09-30

CPE510 Poe not working on Access Point side now

2020-09-30 23:02:21

Model: CPE510

Hardware Version:

Firmware Version:

Set everything up 2 days ago. Has been working great. Had Poe on a temporary mount at cousins house behind us and mount fell down today. Cat6 wire was still connected and no damage but LAN light blinks, shows full signal and then just power light show. It just keeps repeating this pattern. I unplugged cat 6 cable for a few seconds from Poe and no change.

Any help is greatly appreciated!

1 Reply

Yannie

LV4

2020-10-04 11:17:08

Posts: 449

Helpful: 213

Solutions: 28

Stories: 0

Registered: 2020-06-30

Re:CPE510 Poe not working on Access Point side now

2020-10-04 11:17:08

@Bobert540

Cat6 wire was still connected and no damage but LAN light blinks, shows full signal and then just power light show. It just keeps repeating this pattern. I unplugged cat 6 cable for a few seconds from Poe and no change.

It seems like the CPE510 is auto-reboot/reset, you may test the non-working CPE510 with another PoE Adapter from another working CPE510, if it works after replacing the PoE adapter, then the PoE adapter may have an issue, test the non-working PoE adapter with the working CPE510 to confirm it. Otherwise, it's likely that the CPE510 has been defective by the accident.

CPE510 Poe not working on Access Point side now

CPE510 Poe not working on Access Point side now

Information

Voters 0

Tags