TL-SG108E VLAN configuration with single NIC firewall server

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG108E VLAN configuration with single NIC firewall server

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG108E VLAN configuration with single NIC firewall server
TL-SG108E VLAN configuration with single NIC firewall server
2020-10-02 04:53:40 - last edited 2020-10-02 05:02:16
Model: AC500  
Hardware Version: V4
Firmware Version: 1.0.0 Build 20181120 Rel.40749

Hi TP Link support and friends,

 

I am setting up a network with TL-SG108E. Below is the diagram.

 

 

The ISP router is running DHCP service in VLAN 10. It will be connected to the switch port 1. I have a single network interface pfSense router. It is connected to switch port 2 with 2 VLANs: VLAN 10 for WAN and VLAN 1 for LAN. Port 3 to 8 is for LAN with VLAN 1.

 

Could you advise how should I set up these in the switch UI page. I have tried sometimes and was failed. 

 

Appreciate if you could advise on this. Thank you!

  0      
  0      
#1
Options
1 Reply
Re:TL-SG108E VLAN configuration with single NIC firewall server
2020-10-02 09:37:00 - last edited 2020-10-02 09:40:40

@dvckbiz, this topology is not recommended. You will run into serious troubles when using an Easy Smart Switch on the WAN. It will be exposed to the Internet.

 

Get a second NIC for your pfsense router and separate the WAN network from the LAN using the pfsense firewall. You need a firewall between the Internet and your LAN. In order for any router be able to protect your LAN, the router needs two interfaces. Running pfsense on a hardware which has only one NIC makes not much sense at all when not using an ISP-grade managed switch with special security features.

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1642

Replies: 1