Business Community > Switches > TL-SG108E Vlan Setting - 2 VLANs, Wrong DHCP IP
< Switches

TL-SG108E Vlan Setting - 2 VLANs, Wrong DHCP IP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG108E Vlan Setting - 2 VLANs, Wrong DHCP IP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG108E Vlan Setting - 2 VLANs, Wrong DHCP IP
TL-SG108E Vlan Setting - 2 VLANs, Wrong DHCP IP
2021-02-21 05:33:58 - last edited 2021-02-21 05:35:04
Model: TL-SG108E  
Hardware Version:
Firmware Version:

Hi,

 

I have my secondary switch configured as follows:

 

It is plugged into port 1 and set to get ip using DHCP.

 

Question: that switch is getting an IP from VLAN 10. I was expecting it would get an ip from VLAN 1. Am I doing something wrong?

 

It`s cable comes from an Unifi Switch - port profile is configured as "ALL vlans"

 

Can you help me figure out why is that happening?

 

Thanks in advance.

  2      
 
  2      
 
#1
Options
1 Reply
Re:TL-SG108E Vlan Setting - 2 VLANs, Wrong DHCP IP
2021-04-15 09:32:46

I have exactly the same issue with a TL-SG108e-v5 while the other side of the trunk is a switch of almost the same TP-link switch TL-SG108e-v3, so I think it is not an issue of your Unify switch . Fixed it by assigning a static ip to the switch, but this is not the desired solution. I also hope someone has a better solution to fix this without a static IP.

  1  
  1  
#2
Options

Information

Helpful: 2

Views: 818

Replies: 1

Related Articles
TL-SG108E with VLANS, but switch is on wrong IP range
1066 0
About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.