802.1x on switch

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

802.1x on switch

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
802.1x on switch
802.1x on switch
2021-04-18 08:56:43
Model: SG2008P  
Hardware Version: V1
Firmware Version: 1.0.0 Build 20200608 Rel.76470

Hi.

 

I have problem with client authorization. I have configured 802.1x protocol on switch as EAP for Windows NPS Server. When I change 802.1x status to Enable on Port Config, client is not authorized, it is cut off from the network.

 

Other vendor switches do not have problems with authorization with this NPS Server. 

 

In logs on switch I see:

 

MAC added to Quiet Table, port 3, MAC d8-9e-f3-36-d3-51, vid 1.

The MAC is in quiet-period. port 3, MAC d8-9e-f3-36-d3-51, vid 1.

The MAC is in quiet-period. port 3, MAC d8-9e-f3-36-d3-51, vid 1.

RADIUS access-request-response timeout, port 3.

 

NPS Server not receiving any information from switch. Computers have configured 802.1x by built-in Windows dot3svc service. I not using TP-Link 802.1x Client Software and I'm not going to use it. 

  2      
  2      
#1
Options
1 Reply
Re:802.1x on switch
2021-07-07 02:37:14

@LukaszNET man, I have the exact same problem. I know it's been awhile, but I'm wondering if you found a solution?

Thanks in advance!

  0  
  0  
#2
Options