Business Community > Pharos Wireless Bridges > Extending wired network with 2 CPE210's
< Pharos Wireless Bridges

Extending wired network with 2 CPE210's

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Extending wired network with 2 CPE210's

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Extending wired network with 2 CPE210's
Extending wired network with 2 CPE210's
2021-05-28 00:03:54
Model: CPE210  
Hardware Version: V2
Firmware Version:

I'm trying to extend my home network to an office in the garden and I need wired connections in both locations. 

 

I have a  BT Home Hub (router/gateway/dhcp) ip:192.168.1.254,  I've configured an AP CPE1 IP 192.168.1.41 (in the house) which connects to Client CPE2 IP 192.168.1.42 (in garden office).  However I am (as yet) unable to ping 192.168.1.41 (house) from 192.168.1.42 (garden), nor can I reach the Home Hub and therefore have no internet access or useful network yet.  Reading some of the forum posts this seems to be a not uncommon use case.  Is there a scenario configuration you can share with me and the rest of the community to help get this working?

 

Looking forwards to hearing from you,

 

Spike60

  0      
 
  0      
 
#1
Options
1 Reply
Re:Extending wired network with 2 CPE210's
2021-05-28 05:41:54

@Spike60 

 

Hi there, you can log in the management page of the Client to check "Status--Radio Status--Tx Rate/Rx Rate", this is to make sure that the Client is connecting to the AP.

 

There has a pretty detailed instruction when the Client side cannot get internet from the AP side.

https://www.tp-link.com/en/support/faq/2575/

 

Wish this link can help you.

 

 

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 395

Replies: 1

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.