CPE220 CCTV data trasfaring & connective issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE220 CCTV data trasfaring & connective issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE220 CCTV data trasfaring & connective issue
CPE220 CCTV data trasfaring & connective issue
2021-07-05 16:10:02 - last edited 2021-07-05 16:15:38
Model: CP220  
Hardware Version:
Firmware Version:

Dear All,

 

we are using CPE220 for CCTV connectivity, 2 AP on switch (NVR) Site, connect in same switch (10/100mb), station distance estimated 1st- 30 mtr and 2nd 50 mtr, but connectivity not, ping reply too high, ping more then 500ms, when we disconnect 1st AP, every this is good for maximum 5-6 hr, after that station disconnected re conected. please guide us. we want to  use 6 CPE220 devices, (1AP -3 station) other (1AP -1Station)

only 1 camera connect with 1 station.

 

  0      
  0      
#1
Options
2 Reply
Re:CPE220 CCTV data trasfaring & connective issue
2021-07-06 08:45:58 - last edited 2021-07-06 08:48:06

Do you have 2 groups of AP+Client? To build P2P, you need to make sure AP and station face to each other and have clear line of sight. You can follow the FAQ to troubleshoot: 

https://www.tp-link.com/en/support/faq/2575/

 

 

Some issues may be resolved in new firmware. You can also update the firmware.

  0  
  0  
#2
Options
Re:CPE220 CCTV data trasfaring & connective issue
2021-07-06 09:24:45

@Somnus 

 

Do you have 2 groups of AP+Client? To build P2P, you need to make sure AP and station face to each other and have clear line of sight. You can follow the FAQ to troubleshoot: 

https://www.tp-link.com/en/support/faq/2575/

 

 

Some issues may be resolved in new firmware. You can also update the firmware.

 

Thanks for the reply.

Yes i have a P2P connectivity, AP + Client. I have installed CCTV cameras at the location which are centralized through wireless (CPE220). Stations are connected at the camera site and all AP's are at the main centralized pole.

All pairs are connected with maximum strength, Signal quality is approx. Hor/Ver: -49/-54 (in between). 

 

Each station is containing 1 PTZ Camera, Whenever i try to add 2nd station on the same AP (which i at the main location), it connects successfully (strongly) but all network goes down. Ping response go form 3ms to 300ms, even 1000ms+. 

I had also upgraded the modules but the issue is still there.

Adding the cameras at the station side, Adding the new cpe200, causing the network unstable. There are only 4 cameras which have to connect wirelessly through cpe220.

Prompt response or remote support will be highly appreciated.

Thank you.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 404

Replies: 2