CPE710 VLANs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.CPE710 VLANs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Setting up CPE710, have 2 CPE710. one running in AP mode and the other in Client mode. My use case is the following.
Need the 2 CPE701 to connect to each other (done and working).
Need to send multiple VLAN traffice over the wireless bridge. So both CPE's will be connected to switch ports (trunk mode with vlans 10,11,12 presented on both sides).
How do I setup the CPE's to send all the tagged vlan traffic across the bridge created between the two CPE710's (Do I need to setup a different mode on the CPE's?)
I tried to add different SSID on different VLAN's but that wont accomplish what I need, as I can only connect the client device to one SSID.
Thanks
Sarvjit
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Fae Grrr, I could just shoot myself in the foot. Thank you, I was looking at it and could not see that this was enabled RIGHT in front of me. Total USER error.
never work on equipment when Tired or mad.
That did the trick So sorry to waste everyone's time.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 6350
Replies: 11
Voters 0
No one has voted for it yet.