Firmware bug in LACP creation?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Firmware bug in LACP creation?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Firmware bug in LACP creation?
Firmware bug in LACP creation?
2021-10-19 20:14:39
Model: TL-SG3428X  
Hardware Version: V1
Firmware Version: 1.0.3 Build 20210409 Rel.52950
When creating a LAG LACP, I followed the steps from:

https://www.tp-link.com/us/support/faq/991/

Previously I performed a system reset.

Then went L2 Features>LAG>LACP Config /Global Config

 

I selected ports 23 and 24

Status =enable

Group ID = 1

Port Priority = 32768

Mode = Active

 

I pressed Apply.

 

As you can see on the "Lag table" page, the Lag was created but no member ports.
The LAG does not work!





Returning to "LACP Config /Global Config" 
I verifies that the ports are selected.



Possible bug?

 

Thank you for help.
  0      
  0      
#1
Options
2 Reply
Re:Firmware bug in LACP creation?
2021-10-20 02:37:35

@icosta Did you connect the two switches together after you configured them? Have you tried setting the Port Priority to the same value?

  1  
  1  
#2
Options
Re:Firmware bug in LACP creation?
2021-10-21 15:10:05

@icosta Solved.

Cable pinning problem.

Thanks for the support.
  0  
  0  
#3
Options