No clipaging is not working on T1700G-28TQ switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No clipaging is not working on T1700G-28TQ switches
No clipaging is not working on T1700G-28TQ switches
2021-12-05 20:18:36
Hardware Version: V3
Firmware Version: 3.0.0 Build 20190108 Rel.62365(s)

Good evening,

 

I am currently developping Ansible modules for the TP-Link line of switches so their configuration can be automated like the CISCO switches.

All is going very well and we can currently handle the following devices:

 

  • T1500G-10PS
  • TL-SG3452P
  • T1600G-28PS

 

However for the T1700G-28TQ we run into the issue that the 'no clipaging' command is not working and so we can't get all the data in one go. The output is paged showing a 'press any key to see more' message. As we and our customers have a fair amount of TL1700G-28TQ switches, may I ask to have these switches support te 'no clipaging' command also? And when can we expect this? Even the lower end T1500G switches support this command.

 

We are planning to  publish the modules as community supported Ansible modules for TP-LINK switches at the end of this year.

 

Some evidence regarding the missing command:

 

T1700G-28TQN04>enable       

T1700G-28TQN04#show system-info
 Master Unit ID       - 1
 System Description   - JetStream 24-Port Gigabit Stackable Smart Switch with 4 10GE SFP+ Slots
 Device Name          - T1700G-28TQN04
 Device Location      - Kjell
 Contact Information  - kjellvandam@gmail.com
 MAC                  - 60-32-B1-41-3B-96
 System Time          - 2021-12-05 21:07:58

Device Info
Unit 1
 Unit State                 - Ready
 Hardware Version           - T1700G-28TQ 3.0
 Firmware Version           - 3.0.0 Build 20190108 Rel.62365(s)
 Bootloader Version         - TP-LINK  BOOTUTIL(v1.0.0)
 Serial Number              - 2207603000109
 Running Time               - 170 day - 13 hour - 17 min - 12 sec
 Power Supply Module        - Operational
 Redundant Power Supply     - Not Support


T1700G-28TQN04#config

T1700G-28TQN04(config)#no clipaging
--------------------------^
Error: 'no' is not applicable

T1700G-28TQN04(config)#clipaging
-----------------------^
Error: Bad command

T1700G-28TQN04(config)#exit

T1700G-28TQN04#exit

 

Thanks in advance for any help.

 

Kind regards,

 

   Pascal van Dam

0
0
#1
Options