Business Community > Switches > TL-SG3210 Chaning Default IP Address
< Switches

TL-SG3210 Chaning Default IP Address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG3210 Chaning Default IP Address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG3210 Chaning Default IP Address
TL-SG3210 Chaning Default IP Address
2021-12-25 03:38:13
Model: TL-SG3210  
Hardware Version: V3
Firmware Version: 3.0.2 - 20210806 Reference 55686

I am attempting to change the IP address of the TL-SG3210 and cannot get it to take. I am following the directions in the manual and am attempting to edit  the VLAN1  with the VLAN interface IP 192.168.0.1.

I am attempting to change the IP address to 10.0.0.3 Subnet Mask: 255.255.255.0 and Gateway: 10.0.0.1. I have tried it at least four times with teh same results. The IP address is not accepted and the switch requires a reboot in order to recover to the default IP address of 192.168.0.1.

  2      
 
  2      
 
#1
Options
2 Reply
Re:TL-SG3210 Chaning Default IP Address
2021-12-27 05:34:14

@PLCMAN58 

You did mention that you followed the manual. This one maybe?

https://www.tp-link.com/en/support/faq/2122/

 

L3 features>interface, I guess we can edit that on your switch.

 

Make sure you hit the , any luck with that?

  0  
  0  
#2
Options
Re:TL-SG3210 Chaning Default IP Address
2021-12-29 23:40:55
Thanks for the reply. I switched to another computer where I had a static IP address assigned in the range of 10.0.0.xxx instead of using DHCP. I was able to assign the required 192.168.0.xxx to gain access to the TP-LINK 192.168.0.1 default address. I followed the same procedure as before and the TP-LINK switch now has the proper 10.0.0.xxx address.
  0  
  0  
#3
Options

Information

Helpful: 2

Views: 2407

Replies: 2

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.