TL-SG3428 trunk port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG3428 trunk port

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG3428 trunk port
TL-SG3428 trunk port
2022-01-27 07:39:27
Model: TL-SG3428  
Hardware Version: V2
Firmware Version: 2.0.1 Build 20210131 Rel.44230

Dear All,

I created 2 vlan (vlan100, vlan200)

but how to make trunk port on gui?

I couldn't find it on sw gui?

What is the method of trunking over the gui?

 

  0      
  0      
#1
Options
3 Reply
Re:TL-SG3428 trunk port
2022-01-28 06:30:51

@acyhn 

When you create VLAN100 AND 200, you select the tagged ports. e.g. Profile VLAN100, scroll down and find 1-4, select them. 

Create VLAN200, you select port #1-4. 

After you save the config, #1-4 are tagged ports with (trunk)VLAN100 and 200. 

 

PVID is for untagged packets. For untagged ports, you can only set one PVID to get packets from the matching VLAN(PVID)

  1  
  1  
#2
Options
Re:TL-SG3428 trunk port
2022-02-01 07:36:51

@John1234 thank you very much for response;

i want to do

as in the picture;

How do I do the operation on port1? (swich)

 

  0  
  0  
#3
Options
Re:TL-SG3428 trunk port
2022-02-07 20:52:33

@acyhn 

 

I assume you have setup VLAN 1, 100 and 200.

 

In the VLAN list, click edit VLAN1.

Select Ports 1 to 11 and 16 to 20 as untagged member of VLAN1

 

In the VLAN list, click edit VLAN 100.

Select Ports 21 to 24 as untagged member of VLAN 100

Select port 1 as tagged member of VLAN 100

 

In the VLAN list, click edit VLAN 200.

Select Ports 11 to 15 as untagged member of VLAN 200

Select port 1 as tagged member of VLAN 200

 

Above the VLAN list click port config

Set PVID of ports 1 to 11 and 16 to 20 to 1

Set PVID of ports 21 to 24 to 100

Set PVID of ports 11 to 15 to 200

 

Should work now.

 

Kind regards

Martin

 

 

  15  
  15  
#4
Options