Home

Forums

Stories

Knowledge Base

Business Community > Pharos Wireless Bridges > CPE710 only gives 100 Mbps on a 300 Mbps

< Pharos Wireless Bridges

CPE710 only gives 100 Mbps on a 300 Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE710 only gives 100 Mbps on a 300 Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Supernova

2022-02-13 13:54:14 - last edited 2022-03-04 06:05:19

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-02-13

CPE710 only gives 100 Mbps on a 300 Mbps

2022-02-13 13:54:14 - last edited 2022-03-04 06:05:19

Model: CPE710

Hardware Version: V1

Firmware Version: Firmware Version: 2.2.1 Build 20201201 Rel. 56722 (0000)

Hope someone can help. I have two CPE710's one in AP mode and the other in client mode. I used to get +- 295 Mbps from my computer connect by cat5e directly to client. All of a sudden, I am only gettng +- 90-100 Mbps. Testing directly at the fibre modem +- 100 m away, I get 298 Mbps. The AP CPE710 is connect to the fibre modem with a cat5e network cable. (all cables are cat5e). Can it be bad crimping on a cable ?. I noticed on the AP CPE710, the Port0 speed is indicated as 100 Mbps, while on the client it is 1Gbps. My network card is 1Gbps.

1 Accepted Solution

Virgo

LV5

2022-02-14 13:03:28 - last edited 2022-03-04 06:05:19

Posts: 2588

Helpful: 349

Solutions: 191

Stories: 0

Registered: 2021-05-10

Re:CPE710 only gives 100 Mbps on a 300 Mbps-Solution

2022-02-14 13:03:28 - last edited 2022-03-04 06:05:19

@Supernova

It looks like it should only be negotiated to 100M between the AP CPE and the front-end device.

It is recommended that you check the ports and network cables between these two devices, and ideally do the replacement test.

Just striving to develop myself while helping others.

Recommended Solution

1 Reply

Virgo

LV5

2022-02-14 13:03:28 - last edited 2022-03-04 06:05:19

Posts: 2588

Helpful: 349

Solutions: 191

Stories: 0

Registered: 2021-05-10

Re:CPE710 only gives 100 Mbps on a 300 Mbps-Solution

2022-02-14 13:03:28 - last edited 2022-03-04 06:05:19

@Supernova

It looks like it should only be negotiated to 100M between the AP CPE and the front-end device.

It is recommended that you check the ports and network cables between these two devices, and ideally do the replacement test.

Just striving to develop myself while helping others.

CPE710 only gives 100 Mbps on a 300 Mbps

CPE710 only gives 100 Mbps on a 300 Mbps

Information

Voters 0

Tags