CPE610 V2 as a repeater

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE610 V2 as a repeater

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE610 V2 as a repeater
CPE610 V2 as a repeater
2022-02-21 14:48:37
Model: CPE610  
Hardware Version: V2
Firmware Version:

Hi everyone. 

Please I have a tp-link cpe 610 

Is there any why to use it as a repeater?? 

 

I found that the first firmware was support the bride and repeater... Can I downgrade it to the first firmware??! 

 

Thanks in advance 

  0      
  0      
#1
Options
1 Reply
Re:CPE610 V2 as a repeater
2022-02-22 12:37:24

Dear @Linux1

 

Linux1 wrote

Please I have a tp-link cpe 610 

Is there any why to use it as a repeater?? 

I found that the first firmware was support the bride and repeater... Can I downgrade it to the first firmware??!

 

Actually, CPE610 is equipped with directional antenna as it is designed for point-to-point long-distance network transmission,

its wireless signal is mainly focused on its front panel and has a very limited 9 degree angle, we can say that there is almost no signal on its side and back panel.

 

If you use it on repeater mode, the performance may not be so good, and it requires that both the front-end Internet source device and client device should be all within cpe wifi angle.
 

Best Regards!

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 401

Replies: 1

Related Articles