CPE510 and several cameras
Hello I have an instalation with several ip cameras in diferent buildings at diferent heights, I was think in the folowing conection all made with cpe510
Does this gone work or do anyone have some better sugestions.
Thank You
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Mikera ,
Mikera wrote
Hello I have an instalation with several ip cameras in diferent buildings at diferent heights, I was think in the folowing conection all made with cpe510
Does this gone work or do anyone have some better sugestions.
Looking at the pictures you have provided, it is basically possible to set it up in this way, but there are a few points to note.
1. CPE510 is not recommended to be set to REPEATER mode, you can install two CPEs in the bridge location and connect them with a network cable, such as AP CPE))) ((Client CPE - AP CPE))) ((Client CPE.
2. The antenna angle of the CPE510 is limited, so be careful when configuring a point-to-multipoint topology to place multiple Client CPEs at the opposite end within the antenna angle of this AP CPE.
3. This article is for your reference: https://www.tp-link.com/configuration-guides/common-applications-for-pharos-products/?configurationId=22033
Best Regards!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 733
Replies: 5
Voters 0
No one has voted for it yet.