CPE510 deploymeny

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 deploymeny

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE510 deploymeny
CPE510 deploymeny
2022-06-06 17:54:05
Model: CPE510  
Hardware Version:
Firmware Version:

We are deploying CPE510'2 for this environment. We have 3 buildings (each about 200 yards from each other). Building 1 has incoming internet. There are 2 CPE510's in AP mode. Building 2 & 3 are in opposite directions from Building 1. Buildings 2 & 3 havea CPE510 in client mode. The link from 1 to 2 works fine and has been for about 2 years. I am trying to add the same config to building 3. I can see the CPE510 in AP mode at building 1 from building 3 in the survey and I connect to it but I cannot ping the CPE510 IP address from either direction. All units are in the same ip address range. 192.168.1.xxx. Any thoughts on a fix?

 

3c43f7f4c08e4ee2ab64e161bf663f13

File:
CE510 diagram.jpgDownload
  0      
  0      
#1
Options
1 Reply
Re:CPE510 deploymeny
2022-06-07 07:33:01

  @WebHouse 

 

The default IP address of the CPE is 192.168.0.254, make sure you have changed the IP address of the CPE successfully?
Suggest checking if all clients are on the same network segment?
You can ping the CPE, router separately to test the connectivity of each segment.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 268

Replies: 1

Related Articles