Business CommunityAccessoriesSFP optical level
Accessories

SFP optical level

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

SFP optical level

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
SFP optical level
SFP optical level
2022-08-23 19:27:29
Model: SG2210MP  
Hardware Version: V3
Firmware Version: 3.0.0

Hi,

 

I'm searching everywhere web/cli, where is located the SFP optical link value in order to debug fiber issue?

 

regards

 

Armand

  0      
0
#1
Options
3 Reply
Re:SFP optical level
2022-08-24 06:13:36

  @Armand_FUMAL

 

I'm using Omada Controller and TL-SG2210P, it also has two SFP ports and on controller UI, it just shows up like other Ethernet ports. So currently I did not connect anything to SFP port and it shows link down.

  0  
0
#2
Options
Re:SFP optical level
2022-08-28 09:42:00

  @Somnus Yes I have the same, but we need to have the optical output in dbm...

llike this:

 

This usefull to eliminate fibre issue...

  0  
0
#3
Options
Re:SFP optical level
2022-08-29 08:18:05

  @Armand_FUMAL 

It's not available on the controller or web interface. In old days there was a CLI command that can show all SFP status but I can't remember it was which command.

 

I think you can send this requirement to Request&Suggestions block.

 

  0  
0
#4
Options

Information

Helpful: 0

Views: 1926

Replies: 3