How to enable LACP or 802.3ad in CPE 710?

How to enable LACP or 802.3ad in CPE 710?

How to enable LACP or 802.3ad in CPE 710?
How to enable LACP or 802.3ad in CPE 710?
2022-09-14 01:05:02 - last edited 2022-09-14 05:56:45
Tags: #Pharos Control #wan aggregation
Model: CPE710  
Hardware Version: V1
Firmware Version: 2.2.1 Build 20201201 Rel. 56722

I am trying to aggregate my two internet connections with my Asus router. I already have the CPE 710 connected to the AP from a few hundred meters away and internet connection is already enabled and the primary WAN is already working.

However, I can't find anywhere the option to enable LACP on the CPE 710 as instructed in the Asus router guide


(See Snippet below of the guide)

 

This is the error I am receiving from Asus Router Side



How do I make CPE 710 work with WAN Aggregation or how would I enable LACP/802.3ad on the port 0 of the CPE?

My Asus Router btw is an Asus RT-AX86U which has a WAN Aggregation capability on its WAN and LAN 4 ports.

  0      
  0      
#1
Options
2 Reply
Re:How to enable LACP or 802.3ad in CPE 710?
2022-09-14 08:01:45

  @iamjoshua 

 

Your screenshot shows that these settings need to be set on the modem, but the CPE is not a modem, you can read this article describing several modes of the CPE:

https://www.tp-link.com/support/faq/2090/

 

In addition CPE can implement LAG:How to use CPEs to build up a LAG (Link Aggregation) tunnel

  0  
  0  
#2
Options
Re:How to enable LACP or 802.3ad in CPE 710?
2022-09-14 15:09:59

  @Virgo 

Reading the second link, it seems that the CPE710 then doesnt support LACP / Dynamic LAG?. Its just that it is needed on my Asus modem for it to be able to automatically configure the WANs. Is there another hardware that would allow me to sort of convert the WAN output from the CPE to another WAN output with LACP / 802.3ad standard?

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 130

Replies: 2

Tags

Pharos Control
wan aggregation
Related Articles