POE connection of TL-SG2210P to EAP 110

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

POE connection of TL-SG2210P to EAP 110

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
POE connection of TL-SG2210P to EAP 110
POE connection of TL-SG2210P to EAP 110
2022-11-07 07:27:15
Tags: #PoE
Model: SG2210P  
Hardware Version: V5
Firmware Version: 5.0.3

Hi, just bought tp link SG2210P and a couple of EAP110 v4, According to the manual included in the SG2210P, EAP 110 is compatibe with the said Switch. But i cannot power up the EAP110 thru POE switch. 

  0      
  0      
#1
Options
1 Reply
Re:POE connection of TL-SG2210P to EAP 110
2022-11-07 10:31:37 - last edited 2022-11-07 11:21:02

  @Od3 Wait for confirmation from TPlink directly or others that know for sure but...

 

If I am reading the specs correctly for each device,  the EAP110 is Passive POE only and therefore cannot be powered by the TL-SG2210P Active POE.  You would need to power the EAP110 with the provided POE injector and then connect from the Data Port of the EAP110 to the TL-SG2210P. 

 

If you are needing to power the AP with the TL-SG2210P, the EAP225-Outdoor would be the next obvious choice. The EAP225 is 802.3af PoE and 24 Passive PoE and would work with the TL-SG2210P directly.  If you are able to, return any of the EAP110s that are being installed in a location that require power from the TL-SG2210P and replace them with EAP225s.

 

Also I think the EAP110 Port is 10/100 while the EAP225 is Gigabit. May or may not be an important spec to you but when I built my RV Parks Wi-Fi, the POE and Data Spec were the reaons I chose the EAP225 over the EAP110.

 

 

  2  
  2  
#2
Options