Wireless Can't connect well
I am trying to connect two CPE within a 1 km distance (see below for maps) . the hight of pole in Access point side was 15 meter and the hight of pole in client side was 10 meter.
when I connected, the connection from the client side was very slow and received TX and RX are only 1Mbps. how can I increase TX and RX to at least 20 Mbps? please kindly see in below pictures for the network configuration.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
If you connect a PC to Client CPE, what the speed is when you run the speedtest.com.
Have you test the speed from your router?
If you connect to the AP CPE Wifi, what is the speed can you get?
- Copy Link
- Report Inappropriate Content
@Virgo I can't go the the speedtest.com with the internet connection on client side. ping to 8.8.8.8 was over 1500 ms.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
It seems like you can not get internet in client side, suggest you check whether AP CPE is still working, you can ping router IP address on this PC.
If you can not ping through, and AP CPE is working properly, you may reset Client CPE and set it up again.
You can also try different channel and channel width in AP side, just for testing.
- Copy Link
- Report Inappropriate Content
@Virgo I have configured the wireless settings as below.
- Copy Link
- Report Inappropriate Content
It is a good choice to enable Maxtream feature, this function can make the entire connection more stable.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 457
Replies: 6
Voters 0
No one has voted for it yet.