Connect 4 CPE 210
Hi Folks
I was reading this thread https://community.tp-link.com/en/business/forum/topic/84003?sortDir=ASC&page=1
reply #9 suggested a wired link between two CPE units.
I have a similar problem. I need to connect two points that have line of sight, to a third (admin) point that does not have line of sight between all three points.
Think a triangle point at bottom. Point 1 and 2, point 2 and 3 have line of sight, but point 1 and 3 do not have line of sight due to a building
I have 4 CPE 210 and I was setting up today. I had intended to have a single CPE210 on point 1. two CPE210 on point 2 (lined via wire) adn a single CPE210 on point 3.
The goa is have 1 as client sending to an AP on point 2. the AP on point 2 connected to a client on point 2 via wire sending info the a client on point 3.
The above thread talks about connected two point via a wired connection. I do nto know how to do this as the LAN is the POE.
Any advice please??
Do i need an additional piece of hardware to connect two together via a wired connection?