Need help setting up multiple CPE510s within 200m radius
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I need help setting up optimal settings for CPE510 within 200m radius
So the topology goes like this:
800Mbps ISP -> Connected to EAP610-Outdoor via cable
6 CPE510s Connected to the EAP610-Outdoor wirelessly (I cannot use cables on my area even at close range, and the wifi devices cannot pickup enough signal from the EAP610-Outdoor so I really had to use a CPE510)
each CPE510s are connected to a WiFi Router to bring close range connection for each clients.
I left all the settings by default. I noticed when I connected the first two CPE510s (over 50-80meters from EAP610), the throughput and latency is fine and the speed Im getting is 100-200Mbps.
But as I connect more CPE510s, in that area, the EAP610 becomes unstable and all of the CPE510s lag so much and cannot get enough throughput.
All of the 6 CPE510s only receive about 10-15Mbps now. I experimented and tried to disconnect 3 CPE510s and the AP became responsive again.
I suspect the reason is "INTERFERENCE", but maybe there is something else.
I am now planning to buy 3 more EAP610-Outdoor and mesh them all instead of using CPE510s so that the wifi devices will seamlessly roam to the EAP and not relying on the CPEs, but all I invested on the CPE510s will be put to waste if I do this.
Considering I left the settings by default for CPE510s, all of them had the Transmit Power at 25dbm, the Channel Width is 20MHz/40MHz.
What are your thoughts on how I can set the CPE510s properly so that all of them receive a a very good throughput and latency?
