TP-link CPE 510,works only on channel 100

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-link CPE 510,works only on channel 100

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Maestro24

2024-03-31 18:17:18

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-31

TP-link CPE 510,works only on channel 100

2024-03-31 18:17:18

Model: CPE510

Hardware Version: V3

Firmware Version: 2.2.4

Hello,to everyone.
I have two antena tp-link cpe510.
One is in acces point mode,and another is in client mode.And i want to connect them.
They work perfectly on channel 100.
I want to switch the access point to another channel, but the client won't connect in any other channel.
Has anyone had this problem ?
Thanks

1 Reply

Hank21

2024-04-01 08:38:34

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:TP-link CPE 510,works only on channel 100

2024-04-01 08:38:34

Hi@Maestro24

What about the channel width on CPE client? Is it the same as it on the CPE AP?

There are troubleshooting steps to help you set up the AP + Client topology successfully. Please refer to the part 1 and try again.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

TP-link CPE 510,works only on channel 100

TP-link CPE 510,works only on channel 100

Information

Voters 0

Tags