Can't access to pharos Web interface on CPE210

Can't access to pharos Web interface on CPE210

Can't access to pharos Web interface on CPE210
Can't access to pharos Web interface on CPE210
2024-07-19 17:28:12 - last edited 2024-07-22 09:00:14
Model: CPE210  
Hardware Version:
Firmware Version:

I am trying to install 2 new CPE 210 as a link between houses.

 

I have followed all instructions in connecting, changing IP settings and cannot access the default 192.168.0.254. Cannot be found. 

 

Read in an older thread ( 1+ year ago), that there is an old firmware in the CPE210 and using an older browser would work. Did that but no success (Firefox 71).

 

Still, firmware must have been updated since then, right?

  0      
  0      
#1
Options
1 Accepted Solution
Re:Can't access to pharos Web interface on CPE210-Solution
2024-07-22 08:58:48 - last edited 2024-07-22 09:00:14

  @HenrikBage 

Please refer to this link for troubleshooting.

Why cannot I log in to the web management page of the CPE?

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Can't access to pharos Web interface on CPE210-Solution
2024-07-22 08:58:48 - last edited 2024-07-22 09:00:14

  @HenrikBage 

Please refer to this link for troubleshooting.

Why cannot I log in to the web management page of the CPE?

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options