Business Community > Pharos Wireless Bridges > wa5210g full signal , bad bandwidth
< Pharos Wireless Bridges

wa5210g full signal , bad bandwidth

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

wa5210g full signal , bad bandwidth

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
wa5210g full signal , bad bandwidth
wa5210g full signal , bad bandwidth
2014-03-17 04:17:49
Region : Greece

Model : TL-WA5210G

Hardware Version : V2

Firmware Version :

ISP : otenet

I have an wa5210g as AP . I have full signal but my bandwidth is below 2mbps . I am 5 metres near of wa5210g and the throughput monitor shows 1-2mbps . why this is happening?
  0      
 
  0      
 
#1
Options
3 Reply
Re:wa5210g full signal , bad bandwidth
2014-03-17 15:25:45
this happend on usage.. use speed test .. WIRELESS, SPEED TEST write ip of destination and then check,
  0  
  0  
#2
Options
re:
2014-03-17 15:46:20
I run internet speed tests with http://www.speedtest.net . I connect my cell phone to my modem's wifi and speed is about 14-16mbps . when i connect to TP-link AP internet speed is 1mbps with full signal from it .

With speed test i have problem . i put my cell's phone ip and i take the message "the link is broken"
  0  
  0  
#3
Options
Re:wa5210g full signal , bad bandwidth
2014-03-17 21:04:12
Can wire connection with the modem be the problem ? The wire i make is 20 metres and the colors of wire is symmetric ...... orange to orange , white-orange to white-orange , green to green etc.(straight through cable).

the speed test with modem shows 48mbps .
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 926

Replies: 3

About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.