got first AP connected and useable. how do i configure 2nd at my home
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
got first AP connected and useable. how do i configure 2nd at my home
Region : UnitedStates
Model : TL-WA5210G
Hardware Version : V2
Firmware Version : 4.4.5 Build 111209 Rel.40972n
ISP : comcast
I was able to configure AP at the source and can connect with any device I try. My problem is that I can not see it from my home so I need to configure my second antenna at my house to pull it in and give us a good connection. I am seeing it in my config screen and the dbs are hovering at about 50. I will try to get a stronger signal while I wait for some help with configuration. I just don't know how to set it up to connect and bring the signal into the house. I hope someone can give me some pointers, this is my first time using the equipment.
Model : TL-WA5210G
Hardware Version : V2
Firmware Version : 4.4.5 Build 111209 Rel.40972n
ISP : comcast
I was able to configure AP at the source and can connect with any device I try. My problem is that I can not see it from my home so I need to configure my second antenna at my house to pull it in and give us a good connection. I am seeing it in my config screen and the dbs are hovering at about 50. I will try to get a stronger signal while I wait for some help with configuration. I just don't know how to set it up to connect and bring the signal into the house. I hope someone can give me some pointers, this is my first time using the equipment.