Home

Forums

Stories

Knowledge Base

Business Community > Switches > POE problem?

< Switches

POE problem?

POE problem?

POE problem?

2025-06-16 12:26:20 - last edited 2025-06-17 00:45:56

Posts: 9

Helpful: 1

Solutions: 1

Stories: 0

Registered: 2024-08-01

POE problem?

2025-06-16 12:26:20 - last edited 2025-06-17 00:45:56

Model: SG2005P-PD

Hardware Version: V1

Firmware Version: 1.0.11 Build 20250307 Rel.72554

I am using a TP-Link SG2005P-PD switch. It receives power via a POE port from a POE380S POE injector.
I would like to power an EAP211 antenna with POE from one of the ports of the switch. However, the antenna does not start. An IP camera and an EAP653 AP device from the same switch port work fine.
What could be the problem? Is there any way to solve the problem?

0

0

#1

1 Accepted Solution

LV5

2025-06-16 12:55:17 - last edited 2025-06-17 00:45:56

Posts: 2835

Helpful: 1013

Solutions: 398

Stories: 0

Registered: 2018-08-17

Re:POE problem?-Solution

2025-06-16 12:55:17 - last edited 2025-06-17 00:45:56

The EAP211 can only be powered from these sources, it is not supported on SG2005P-PD

Recommended Solution

3

3

#2

2 Reply

LV5

2025-06-16 12:55:17 - last edited 2025-06-17 00:45:56

Posts: 2835

Helpful: 1013

Solutions: 398

Stories: 0

Registered: 2018-08-17

Re:POE problem?-Solution

2025-06-16 12:55:17 - last edited 2025-06-17 00:45:56

The EAP211 can only be powered from these sources, it is not supported on SG2005P-PD

Recommended Solution

3

3

#2

LV1

2025-06-17 04:22:25

Posts: 9

Helpful: 1

Solutions: 1

Stories: 0

Registered: 2024-08-01

Re:POE problem?

2025-06-17 04:22:25

Thank you!

0

0

#3